The D'MAND® S-Series converts
standard plumbed homes into D'MAND®
Systems. At the push of a button, the
S-Series pumps cold water sitting in the
hot water line into the cold water line
and back to the water heater. The "off
sensor" automatically shuts off the
pump and closes the zone valve when hot
water arrives at the system. Now you have
hot water instantly at the fixture and
anywhere else plumbed off of the main
line.
The S-70T models
are designed for homes under 3500 square feet.
They are suitable
for use in
most homes
and small
businesses.
They weigh
7 lbs.
Dimensions
are 11" wide,
8"
deep, and 6" tall.
(This model is adaptable to any tankless water heater. Please review our tankless water heater section for proper sizing.)
The patented PDV (Check Valve) is built
right into the pump housing, reducing
the number of external devices. It is
adequate for runs of up to 100 feet. The
pump carries a five year warranty.
The S-70T is
available in
three configurations.
The base configuration
is the S-70T-PF
Kit as shown
below.Pause your mouse over the other model numbers to see the differences in
the photos. Click any model number to add that item to the shopping cart.
(If you want to buy more than one, you can change the quantity in the cart later.)
 The Tees that come with the kits have changed! See what's new!
|
Patented D’MAND circuit board and PDV
(Check Valve). Two ½" threaded
male adapters pre-assembled for easy installation,
two brass “T” compression
fittings, two stainless steel flex-lines,
one hard-wired button. For runs up to 100 feet.
S-50T